Question: What Is Throttle Free Play?
One hallmark of a skilled rider is the ability to precisely deliver the right amount of throttle at the right time. To check the throttle free play, hold the grip between your fingers and roll it back and forth until you begin to feel the pull of the cable. Pick a spot on the grip and watch it to measure the free play.
What is the free play of throttle cable?
To check the free play, roll the throttle forward until it stops and take note of the position, then gently open the throttle until you feel the tension on the cable. The distance from the closed position to the tension point is your free play.
Should there be play in a motorcycle throttle?
Measuring Throttle Free Play: Most motorcycle manufacturers recommend between 2 to 3mm of throttle free play, but check in your owner’s handbook to be sure. When you’ve twisted the throttle to feel the tension, measure between the two points.)
What is the throttle cable?
Your car’s accelerator cable, also known as a throttle cable, is a braided metal wire that connects the gas pedal to the engine throttle plate. Although many newer cars use an electronic throttle control system, accelerator cables are still frequently used in cars to control the engine.
Why is my bike over revving?
A motorcycle idles high when it is getting too much of an air and fuel mixture in a low speed or neutral position. This is usually caused by the idle screw on the carburetor being out of adjustment, an out of place throttle handle screw, a bad carburetor throttle spring, or a sticky throttle or throttle cable.
When should I replace throttle cable?
Replacing your throttle cables. If your inspection reveals any damage, you’ll need to replace your throttle cables. You might also need to replace them to accommodate a different handlebar.
What is free play motorcycle?
Adjusting your clutch lever “Free play” is process of achieving the correct amount of slack of the clutch cable, as measured at the pivot point of the clutch lever. The clutch cable is always engaging the clutch (just a little bit), separating the clutch plates, and causing accelerated wear.
What is free play bike?
Normal clutch lever free play is 10-20 mm at the lever. Start the engine, press the clutch lever and shift into gear. Make sure the engine does not stall, and the motorcycle does not creep. Gradually release the clutch lever and open the throttle. The motorcycle should start smoothly and accelerate.
How does a motorcycle throttle work?
The throttle controls how much air is allowed to flow through the carburetor, and the flow of air is what controls how much fuel is also fed into the engine. The Venturi Principle/Effect states that when air flows through a restriction of a tube (narrowing), the air speed increases, and air pressure decreases.
Why does my motorcycle bogs down when I give it gas?
Causes of Bogging and Possible Solutions The most common reason is that your air/fuel mixture is inefficient or dirty. If your air filter is clogged or has a lot of dirt. It could be bogging down the engine. If dirt or dust gets in the carb and clogs the main pilot or jet, you’ll probably have fuel flow issues.
Why does my bike accelerate automatically?
There is a small screw in the carburetor which sets the idle speed of your bike which sets rpm for the idle state, This can be manually adjusted, tune the screw as recommended in the user manual or tell a mechanic to adjust the slow speed. This will solve the problem, if it still gets accelerated.
What is Motorcycle Clutch?
In manual transmission motorcycles, the clutch is the component in the engine that engages and disengages power from the engine to the transmission in order to change gears. In other words, it enables the rider to turn on or off power to the rear wheel to change gears.
