Readers ask: Where Do You Put Pocket Door Guides?

Pocket door guides are small plastic retainers that are installed at the bottom of the door jamb.

Do pocket doors need a bottom track?

Typically, pocket doors have an upper track only, but if you plan ahead you can have a bottom track. This gives the sliding door a robust fixing and makes it less likely to flap about when in the open position. It involves fixing the track into the floor — one way to do this is with a router in a timber floor.

Do you put trim around pocket doors?

Trimming Pocket Door Jambs Pocket door frames consist of both metal and wood components. One each room side of the pocket side of the frame there is a piece of 1x material that the drywall can be screwed to. On the other side you just install a full width piece of jamb trim from floor to top.

What is floor guide?

The Floor Guide fastens to the floor with two screws to keep wood doors on track and eliminate excess back and forth movement.

How far in should a pocket door go?

A pocket door requires a “sleeve” inside the wall to retract into. For a traditional 32-inch-wide interior door, you’ll need at least 66 inches of linear wall space: 32 inches for the door and the rest for the housing.

Do pocket doors have a track on the floor?

But because pocket doors from the past ran along raised tracks on the floor, the tracks were a tripping hazard, so builders and homeowners avoided pocket doors when possible. But today’s pocket doors use ceiling tracks or recessed floor tracks, so homeowners and builders are again using them when appropriate.

You might be interested:  Quick Answer: Is Stevia Sugar Free?

Should pocket doors be solid or hollow?

Use a Solid Core Door. The type of door you install can also make a difference in how your door operates. We’ve found that solid core doors with a little more weight to them glide on the pocket door track better than hollow core doors. The extra few pounds just makes it better in my option.

Can you install a pocket door without removing drywall?

If you simply want to replace a pocket door or remove it in order to repair it, you don’t have to tear into the drywall! That’s great news. All you have to do is lift the door off the sliding track. To replace the whole door, you have to get the old door out by using the same method – getting the trim off.

How do you shave a pocket door?

Shave the bottom of the pocket door so it clears the tile. You have about an inch and a half of plug inside the hollow core door to trim. Don’t shave more than 3/4″ off the bottom. If you can, trim equal amounts off the top and bottom.

What is a jamb saw used for?

A jamb saw is a special-purpose electric power saw that is designed to make undercuts around door jambs (casing at the bottom of the door). You will do these undercuts to slide in the laminate or wooden flooring below the door casing which will give it a clean appearance. Hence, they are also called undercut saws.