Readers ask: How Do You Cut Wrought Iron Spindles?

Using a Portaband saw or a chop saw with a metal cutting blades are the best methods to cut your wrought iron balusters. Most balusters can be cut from only the bottom and installed fine, however if you want your pattern to line up at a specific height it is best to cut from top and bottom.

How do you cut through wrought iron?

An oxyacetylene torch or a titanium-coated, high-speed steel saw blade on a hacksaw or right angle grinder can all be used to cut wrought iron. The torch can cut close as long as the rail is attached to concrete or some other nonflammable surface.

How far apart should wrought iron spindles be?

Balusters are the vertical guards that support the handrail. They must be installed close enough that the space between them is less than 4 inches. Most city inspectors carry a 4-inch ball with them to test the spacing. Installed balusters should withstand 50 pounds of pressure exerted over a 1-sq.

How do you cut wrought iron balusters?

Using a Portaband saw or a chop saw with a metal cutting blades are the best methods to cut your wrought iron balusters. Most balusters can be cut from only the bottom and installed fine, however if you want your pattern to line up at a specific height it is best to cut from top and bottom.

What will cut through iron?

Solid cast iron can come in the form of griddles, old fireplaces or even wood-burning stoves. But when cutting through solid cast iron, a saw or cutting tool with a diamond saw blade is the best choice to make a cut in a straight line.

You might be interested:  Readers ask: What Was The Religion In India Before Hinduism?

What angle do you cut stair spindles?

It is not done here at our shop. This is because every stair is slightly different, and cutting the angle on site avoids potential problems with the installation. We recommend the use of a table saw and miter gauge: Set the angle of your table saw to 15 degrees (to match the angle of the sloped bottom rail).

Does hacksaw cut metal?

A hacksaw is a fine-toothed saw, originally and mainly made for cutting metal. On hacksaws, as with most frame saws, the blade can be mounted with the teeth facing toward or away from the handle, resulting in cutting action on either the push or pull stroke.

How do I evenly space my balusters?

It is also possible to measure the entire length of the balustrade and then divide it evenly so that you get a spacing close to 4 inches. For example, if your balustrade is 161 ½ inches long, you might use 41 balusters evenly spaced 3.94 inches from each other—roughly 1/32 of an inch shorter than 4 inches.

Are balusters and spindles the same thing?

A baluster and spindle is actually almost the same thing, but the word spindle is more commonly used because it is easier to remember and say. Balusters usually rest on a footing; this could be a step, floor or deck, whereas, spindles are supported by a horizontal rail at the bottom that is attached to the posts.

How tall should balusters be?

Guards, spindles, or balusters must be 34” to 38” when measured from the nose of a 10-inch deep tread. Interior stairwells require that anything over 2 steps or 3 risers would need a rail. Balusters, or other options of vertical guards that support a handrail, should be able to support 50lbs over a 1-square-foot area.