FAQ: How Do You Mix Quikrete For Posts?

Fill the hole with Fast-Setting Concrete up to 3 to 4 inches below ground level. Pour about a gallon of water per 50 lb bag into the hole and allow the water to saturate the concrete mix. Wait about 4 hours to begin constructing your fence or applying heavy weight to your post.

What is the best concrete mix for posts?

In terms of the ratio to use for a concreting fence posts, the best mix is a mix of 1:2:4 (1 cement, 2 sand, 4 aggregate). Concrete is always best mixed using a cement mixer to ensure it’s even, but if you only need to mix a little, hand mixing is ok (see mixing concrete project above for tips on how to do this).

How many bags of quikrete do I need for a 4×4 post?

When you’re installing a fence post, the amount of concrete you need will be calculated based on the diameter of your fence post and how high the post is above ground. Most fence post holes will need between 1 – 4 bags of concrete to securely hold the post in place.

Do you have to mix concrete for post holes?

Fast-setting concrete is ideal for setting posts because there’s no mixing —you simply pour the dry concrete from the bag right into the hole, then add water.

Is quikrete good for fence posts?

For a small to mid sized job I recommend going with premixed. The best concrete mix for fence posts I’ve found is Quikrete Fast Setting Concrete Mix in a 50 lb bag. It’s 4000 psi, easy to work with, sets up fast, and doesn’t need to be mixed. Just pour it in the hole and soak with water.

You might be interested:  Often asked: What Does Sac Stand For In Medical Terms?

Can you mix quikrete in the hole?

Setting Posts in Concrete With Fast-Setting Concrete there is no mixing or tools required – You simply pour the dry mix right from the bag into the hole, then add water. Fast-Setting Concrete sets in about 20 minutes so you can quickly move onto the next step of your outdoor project.

How much post mix do I need per post?

How much Post Mix do I need for a fence post? The exact amount of Post Mix Concrete needed will vary depending on the width and depth of the hole, but as a general rule you’ll need about one and a third bags for a standard fence post.

Is 2 feet deep enough for fence posts?

2 feet is the minimum depth that you should dig your fence post holes for. To dig the holes one-third to one-half of the post’s aboveground height, is a general formula. The deeper you dig the holes, the more stability your fence has.

How big of a hole do I need for a 4×4 post?

A general rule of thumb is to dig the diameter of the hole at least 3-4 times the diameter of the post. For example, if setting 4 x 4 wood posts, dig holes 9-12″ in diameter. Posts should be centered in the hole and the posts should always have concrete under them.

Can pressure treated posts be set in concrete?

Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. Concrete should be poured around the post – no concrete under the post.

You might be interested:  What does rome wasn't built in a day mean?

What happens if you add too much water to quikrete?

NOTE: the more water that is added to the mix the weaker it becomes; adding one extra quart of water per 80 lb bag can reduce the strength of the concrete by up to 40%.

Can I mix concrete in a hole?

Fill the hole with Fast-Setting Concrete up to 3 to 4 inches below ground level. Pour about a gallon of water per 50 lb bag into the hole and allow the water to saturate the concrete mix. Wait about 4 hours to begin constructing your fence or applying heavy weight to your post.